русский
Español
FrançaisIndustry News
Adhesion Promoter | Waterborne System
In waterborne coating, sealant, and adhesive formulations, filler-polymer interface compatibility is the defining factor for adhesion and mechanical performance — and it is often the most overlooked variable in formulation design.
When fillers and polymer matrices in waterborne systems are incompatible at the interface level, adhesion loss, weak mechanical performance, and storage instability all follow. Simply adding more resin cannot compensate for a fundamentally incompatible interface — targeted interfacial chemistry is required.
Common Problems in Waterborne Systems
Adhesion Loss
The coating lifts, peels, or fails to maintain bond strength to the substrate under service conditions — the most visible and costly failure mode.
Poor Filler Dispersion
Incompatible fillers aggregate rather than distributing uniformly, creating localized weak points throughout the cured film.
Weak Mechanical Performance
Tensile strength, flexural strength, impact resistance, and modulus are all below target — limiting performance in demanding applications.
Storage Instability
The formulation's performance shifts over time during storage, creating quality inconsistency between production batches.
Why Increasing Resin Content Is Not the Answer
A common corrective action is to increase resin loading or adjust the filler ratio. These adjustments rarely solve the root problem.
The key insight: Adhesion in filled waterborne systems depends primarily on interfacial bonding quality — not resin quantity. If the interface between filler particle surfaces and the polymer matrix is incompatible, adding more resin simply adds more of the same incompatible matrix. The interface remains weak, and adhesion deficiencies persist — while formulation cost increases.
The key insight: Adhesion in filled waterborne systems depends primarily on interfacial bonding quality — not resin quantity. If the interface between filler particle surfaces and the polymer matrix is incompatible, adding more resin simply adds more of the same incompatible matrix. The interface remains weak, and adhesion deficiencies persist — while formulation cost increases.
The Solution
DH-7269S — Waterborne Adhesion Promoter
Epoxy-Modified Polysiloxane | Bifunctional Coupling Agent
DH-7269S is an epoxy-modified polysiloxane waterborne adhesion promoter. It functions as a bifunctional coupling agent: one end anchors to inorganic filler surfaces (silicates, carbonates, metal oxides), while the other is reactive with the organic polymer matrix. This creates a chemical bridge across the interface — transforming an incompatible boundary into a bonded interface.
Adhesion Improvement
Excellent
Flexural Strength
Very Good
Tensile Strength
Very Good
Impact Resistance
Good
Storage Stability
Very Good
| Product | Chemical Type | Applications |
| DH-7269S | Epoxy-modified polysiloxane | Waterborne coatings, waterborne sealants, waterborne adhesives, metal surface treatment, composite material systems |
Key Takeaway
For waterborne systems, interfacial compatibility between fillers and the polymer matrix determines adhesion and mechanical performance. Simply adding more resin cannot compensate for a fundamentally incompatible interface. DH-7269S addresses the root cause — improving filler dispersion, strengthening interfacial bonding, enhancing key mechanical properties, and providing more stable long-term performance across waterborne coating, sealant, and adhesive applications.
Experiencing Adhesion Issues in Your Waterborne System?
Request a technical data sheet or sample of DH-7269S from our technical team.
